Protect your endplates or the leading edge of your splitter with these steel pucks. Made of .187″ thick plate. Each plate comes with two 5mm holes and hardware to be mounted to your splitter. These arecompatible with our V3 Track Splitter Endplates. Our steel pucks are more durable than Ti against wear resistance.

Designed to be mounted vertically on the edge of a blade, or at the bottom of a foot plate / endplate / end fence.

NOTE! They should not be used flat on a blade – the bolt will grind off before the puck.

PucksSold Individually.

Singleincludes:

– qty 1 -steel puck & hardware

2 Packincludes:

– qty 2 – steelpucks & hardware

4 Packincludes:

– qty 4 – steelpucks & hardware

Looking for other splitter parts?

• Other Splitter DIY / Replacement Parts

Disclaimer –

Off road use only, not intended to be used on public roads. This product is not DOT approved. This product may alter the handling of the vehicle. The buyer is responsible for all modificationsmade toyour car. CJM Industries llc assumes no responsibility or liability as a result from altering your car with our products.This productmay not comply with Federal, State, Province, and/or Local laws, ordinances, and regulations. Buyer takes all responsibility to conform to all applicable laws and regulations for road use, especially pertaining to safety.