Protect the edge of your splitter with these wear pucks. Made of 13mm/ .5″ thick stainless plate. Each plate comes with two M6 threaded holes 40mm on center and hardware to be mounted to your splitter. Our stainless pucks are more durable than Ti against wear resistance.

Designed to be mounted on the bottom of a splitter or foot plate / endplate / end fence.

PucksSold Individually.

Singleincludes:

– qty 1 – puck & hardware

2 Packincludes:

– qty 2 – pucks & hardware

4 Packincludes:

– qty 4 -pucks & hardware

Looking for other splitter parts?

• Other Splitter DIY / Replacement Parts

Also Known as:

• Skid Blocks
• Wear Pads
• Scuff Plates
• Wear Pucks

Disclaimer – Off road use only, not intended to be used on public roads. This product is not DOT approved. This product may alter the handling of the vehicle. The buyer is responsible for all modifications made to your car. CJM Industries llc assumes no responsibility or liability as a result from altering your car with our products. This productmay not comply with Federal, State, Province, and/or Local laws, ordinances, and regulations. Buyer takes all responsibility to conform to all applicable laws and regulations for road use, especially pertaining to safety.